Bulletin 115

Lighting Information  

HOME ABOUT US UVC & OZONE BULLETINS PRODUCTS LINKS CONTACT US

 

To obtain normal ballast life and maximum efficiency from a fluorescent lighting installation, fixtures should periodically be inspected for:

·        Lamps cycling on and off

·        Heavy lamp end discoloration

·        Blinking lamps

·        Dim lamps

·        Slow starting lamps

·        Inoperative lamps

 The significance and correction of these conditions may vary with the type of lamp (see sections headed "Slimline" or "Rapid Start" lamps).  However, there are general rules which apply to all types.  They are:

¨      Lamps should be replaced when they reach 80% of their rated life.  Your lamp supplier has more specific information available regarding lamp maintenance procedures.

¨      Lamps should be cleaned periodically, especially Rapid Start, since an accumulation of dirt combined with high humidity conditions can make starting the lamps difficult.

¨      Line voltage should be checked at the fixture and compared with the ballast rating to be sure it is within prescribed limits.

¨      Lamps cycling on and off may be a warning that the ballast is operating at too high a temperature which causes the automatic resetting thermal protector within the ballast (Class P or non-Class P) to perform its function.

 

Troubleshooting Fixtures with Slimline Lamps

 For fixtures using Slimline lamps, this additional procedure should be followed:

·        Heavy lamp end discoloration indicates approaching end of life necessitating immediate lamp replacement.

·        Inoperative lamps should be replaced by known good lamps.

·        If the good lamp does not operate: check sockets, wiring, line voltage, polarity and grounding.

·        When the above items appear to be correct and the lamps still do not operate properly, it may be assumed that the ballast is inoperative and should be replaced.

 

Inoperative Slimline lamps should not be left in a fixture as the ballast will overheat and burn out prematurely.

 

BACK TO TOP

 

HOME / ABOUT USPRODUCTSUV AND OZONE / CONTACT US  


Fuller Ultraviolet Corporation
9416 Gulfstream Rd.
Frankfort, IL. 60423
Ph. 815-469-3301 Fax 815-469-1438
e-mail fulleruvcorp@mindspring.com